а что такое митчел? а то я один опус с 10 рецептами опробовал. чуть выше по ветке написал, что ничего там ненашел
Этот опус как раз из Митчела. В нем все есть. Интересны эти два варианта :
CHANGE OIL SOON/OIL CHANGE REQUIRED MESSAGE - PROCEDURE 7
Oil Life & Oil Life Start Value Reset:
1. Place the ignition in the RUN position with the engine off (KOEO).
2. Press and release the TRIP/RESET button until SETUP MENU HOLD RESET is displayed.
3. Press and hold the TRIP/RESET button until RESET FOR SYS CHECK (2006 early build) or
SYSTEM CHECK HOLD RESET (2006 late build and later) is displayed.
4. Release the TRIP/RESET button.
5. Press and release the TRIP/RESET button to scroll through the system check menu items until HOLD
RESET IF NEW OIL is displayed.
6. Press and hold the TRIP/RESET button until OIL LIFE SET TO 100% is displayed.
NOTE:
If the oil life start value was set to 100%, the next setting would be 90%.
If the oil life start value was set to 10%, the next setting would be 100%
7. Release the TRIP/RESET button. The oil life is now reset.
8. To change the oil life start value, press and hold the TRIP/RESET button until the oil life display
indicates the next oil life start value.
9. Repeat Step 7 for each desired 10% reduction in the oil life start value down to 10%.
With Message Center Instrument Cluster
Oil Life Reset:
NOTE:
For 2008 and later vehicles, it may be possible to start with step 2.
1. Press and release the SETUP button until the message center displays PRESS RESET TO BEGIN
SYSTEM CHECK.
2. Press and release the RESET button until the message center displays HOLD RESET IF NEW OIL.
3. Press and hold the RESET button for 2 seconds until the message center displays OIL CHANGE SET
TO 100%.
Oil Life Start Value Reset
1. Press and release the SETUP button until the message center displays OIL LIFE START VALUE
SET TO XX%.
2. Press and release the RESET button to lower the percentage by 10% (down to 10%) for each button
press or return the value to 100%.
===
CHANGE OIL SOON/OIL CHANGE REQUIRED MESSAGE - PROCEDURE 9
Base Instrument Cluster
1. Press and release the ODO/TRIP button to toggle between the odometer and trip odometer displays.
2. Press and release the ODO/TRIP button again to toggle between the trip odometer display and the
OIL LIFE XX% display.
3. Press and hold the ODO/TRIP button for approximately 2 seconds or more until OIL LIFE 100% is
displayed.
4. Press and release the ODO/TRIP button to return to the odometer display.
Message Center Instrument Cluster
1. Press and release SETUP button until the PRESS RESET AT OIL CHANGE is displayed.
2. Press and release the REST button until the HOLD RESET TO CONFIRM is displayed.
3. Press and hold RESET button until OIL LIFE SET to 100% is displayed.